The topic of this article may not meet Wikipedia's notability guidelines for companies and organizations. Please help to demonstrate the notability of the topic by citing reliable secondary sources that are independent of the topic and provide significant coverage of it beyond a mere trivial mention. If notability cannot be shown, the article is likely to be merged, redirected, or deleted. Find sources: "Micro Engineering Solutions" – news · newspapers · books · scholar · JSTOR (May 2015) (Learn how and when to remove this message)

Micro Engineering Solutions, Inc.^[1] was a CAD/CAM (Computer Aided Design / Computer Aided Manufacturing) software company founded in 1986 by Lynn and Jim Hock and Bill Harris in Farmington, Michigan. The initial product was "Solution 3000", a PC-based CAD/CAM system that ran on a standard IBM PC AT (or clone), running under IBM PC DOS, with 640 KB of memory. Additional required hardware included a math coprocessor, a 20 MB hard disk drive with floppy disk backup, a graphics display interface, and a graphics monitor.

Solution 3000 featured true full 3D modeling capability, including both design and manufacturing capabilities. Optional packages included:

Advanced Surfacing / NC Machining Advanced Conversion Programs: IGES (Initial Graphics Exchange Specification), DXF (AutoCAD Format),^[2] DES (General Motors), Ford Standard Tape, and Chrysler's format.

In 1990, Micro Engineering Solutions, Inc. was purchased by a group of investors that included Morganthaler Ventures, 3I Ventures, and GeoCapital.^[3]

In 1991, the Board appointed Ken Spenser as President and CEO.^[4]

On October 19, 1992, Autodesk Inc, Sausalito CA acquired Micro Engineering Solutions.^[5]